U2426 Engine Code Repair
Meaning of U2426 engine trouble code is a kind of network trouble code and when the check engine light comes U2426 code on the first you should check is the gas cap. Pull over, retighten it, and take a look at the cap to see if it has any cracks in it. Continue driving and see if the check engine light turns off. Alternately, you can purchase a gas cap for about $3 at an auto parts store. All you need to do is take the old one off and screw on the new one. If you've already made it to the store, you might as well just replace it. While not car-threatening, it's good to take care of this right away to improve gas mileage.
U2426 Fault Symptoms :
- Check engine light comes on
- Engine stalling or misfiring
- Engine performance issues
- Car not starting
If one of these reasons for U2426 code is occuring now you should check U2426 repair processes.
Now don't ask yourself; What should you do with U2426 code ?
The solution is here :
U2426 Possible Solution:
Air Conditioning Pressure Sensor (ACP) Insufficient Pressure Change Each time the A/C clutch engages, the PCM is looking for a pressure change in the refrigerant. If the change in pressure is outside of the calibration the DTC will set. A/C system mechanical failure Open ACP or VREF circuit A/C sensor damaged A/C system electrical failure A/C clutch always engaged Verify A/C system function, including refrigerant charge.
U2426 Code Meaning :
U
OBD-II Diagnostic Network (U) Trouble Code For Engine
2
Fuel And Air Metering (Injector Circuit Malfunctions Only)
4
Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
2
Engine Shutoff Solenoid Malfunction
6
Crankshaft Position Sensor B Circuit Malfunction
The poor running symptoms are consistent with a MAP sensor malfunction. In addition, in some cases, a bad MAP sensor will not throw a code. Again, the ELD code likely represents a separate wiring issue.
U2426 OBD-II Diagnostic Network (U) Trouble Code DescriptionU2426 engine trouble code is about Crankshaft Position Sensor B Circuit Malfunction.Main reason For U2426 CodeThe reason of U2426 OBD-II Engine Trouble Code is Throttle/Pedal Position Sensor/Switch A Circuit Intermittent. |
U2426 DTC specifically refers to the camshaft (cam) timing. In this case, if the cam timing is over-retarded, the engine light will be illluminated and the code will be set.